There are many possible reasons for your PC to stop booting. They range from simple and easy to fix to much more complicated. Whatever the reason, your files are very likely to be safe. As long as no disasters have occurred, there is no reason to worry about your data. If the worst happens and you can’t get your PC to work, you can always remove the hard drive or SSD and access it from another device. Even though it may seem like there’s nothing you can do to fix your computer, there are many options you can try before spending a lot of money on a new computer. Below are some possible causes and how you can fix them.
Ways to Fix PC Won’t Turn On
Check for power supply problems
Many of you might find it hard to believe, but the most common reason a computer won’t turn on is because you didn’t turn it on in the first place! The first step in troubleshooting an idle computer should be to make sure the computer is turned on. up no way. If there are no lights flashing, no fans running, and nothing appears on the screen, the cause is most likely a power issue. First, examine the entire length of the power cord for cracks and dents or frayed insulation. The power cord is probably faulty if you find any faults or the power plug smells like burnt plastic.
internal wiring
The motherboard usually shows if it can be turned on with an LED light. If your new PC gets power but still won’t turn on, you need to check your case for loose or faulty cables. If your PC won’t turn on after it’s built, poorly connected components could be the reason, especially if you’re a novice PC builder. Always make sure they are properly clicked. If you are using a pre-built system, be aware that opening the PC may void your warranty. Safety first! Always disconnect your PC from the power supply before opening it.
Power Button
The motherboard usually indicates whether it is receiving power with an LED light. If it is, but the fans aren’t spinning, the problem is probably with the power switch on your computer’s case or the cable that connects it to the motherboard. In order for your PC to turn on when you press the power button, you must correctly connect the power button to the motherboard. If the two are not connected, nothing will happen when you press the power button. The power switch wires must be connected to the jumpers on the motherboard, which are usually located in the lower right area of the motherboard. Since these pins are usually unlabeled, it’s probably wise to consult your motherboard manual as there should be a good diagram showing what goes where.
let the battery charge
you put your laptop away for awhile and now it won’t turn on? So you plugged it in and it still won’t turn on? Don’t worry, because your laptop is probably fine; your battery is completely discharged. to get your laptop working again, let it charge for about thirty minutes before trying to turn it on again.
Decrypt POST and Beep codes
When you turn on the computer, does it immediately turn off? It may not turn on, but some or all of the internal hardware lights turn on up or flash and stop suddenly. You can also hear the fans inside the computer turn on. How can you fix a computer that turns on and then turns off? Some motherboards are equipped with power-on self-test (POST) codes and beeps. These are audible and visual signals that emit a specific signal (beep code) through the system speakers to inform you that the computer has failed POST
Final Words
We hope you like our article about how to fix PC does not turn on. You sit in front of your computer, press the button button like you do everyday and… nothing happens. Maybe the computer won’t turn on, maybe it boots up but it shuts down immediately, or you may see a blue screen. There is no obvious error, so why does the computer not boot up? Here are some troubleshooting steps.
